Materialload Material quantity reference

Sand calculator

Enter the area and the depth of sand you need. The result comes back in cubic yards, tons and bags, with the density assumption stated on the page.

Sand calculator live
ft
ft
in
%

Paver base is usually 1–2 in after compaction.

$
You need
— cu yd
—
Weight —
Bags —
Area —
Depth —
$
Material cost $—
Check sand prices

Affiliate link. The price above is calculated from the unit price you entered — it is not a quote.

A 20 × 10 ft paver area at 1 inch deep needs about 0.68 cubic yards of sand — 18.3 cubic feet once a 10% waste allowance is included — which weighs roughly 0.92 tons at 100 lb per cubic foot.

What the calculator assumes

  • Area is the paver field, sandbox or trench footprint, measured flat.
  • Depth is the finished sand thickness, not the depth of the excavation. A 1 inch bedding layer over a base that is 4 inches low is 5 inches of digging.
  • Density is 100 lb per cubic foot. Dry masonry sand runs 95–105; wet sand reaches 110–120.
  • Waste defaults to 10%, which covers screed spill and the fact that a bedding layer is never perfectly uniform.

A cubic yard is 27 cubic feet — not 3. Sand ordered as “3 yards” and delivered as 3 cubic feet is a common and expensive misunderstanding.

Sand by job

Job Depth Sand per 100 sq ft
Paver bedding layer 1 in 0.34 cu yd
Sandbox 12–18 in 3.1–4.6 cu yd
Flagstone bedding 1–2 in 0.34–0.68 cu yd
Pool base (vermiculite mix) 2 in 0.68 cu yd
Sand-set brick 1 in 0.34 cu yd

A 4 × 4 ft sandbox filled 12 inches deep is 16 cubic feet, or 0.6 cubic yards — about 1,600 lb. That is the point where most people discover a sandbox needs a truck delivery, not twelve bags.

Bulk or bags

Bagged sand wins in exactly two situations: under half a cubic yard, or no vehicle access for a pallet. Everywhere else the arithmetic is brutal — 54 bags to make one yard, at $4–5 a bag against $30–45 a yard in bulk.

For a sandbox, 12 bags of 50 lb is a reasonable compromise. For a 600 sq ft paver patio you need 2 cubic yards and bags stop being a choice at all.

Where the number goes wrong

Compaction of the base, not the sand. Sand is not compacted — it is screeded. If the gravel base beneath it was not compacted in lifts, the pavers will settle no matter how much sand you add.

Sand loss into the base. On an open-graded base, the first inch of sand disappears into the voids. Landscape fabric between base and bedding stops that, and it is the single cheapest fix on the job.

Wet sand by weight. If the supplier sells by the ton after rain, the same volume costs more. Order bedding sand by volume.

FAQ

Sand questions

How much does a yard of sand weigh?

About 1.35 tons dry. Sand sits near 100 lb per cubic foot and a cubic yard is 27 cubic feet, so 2,700 lb. Wet sand is heavier by 10–15% because water fills the voids between grains — the volume you ordered did not change.

How deep should sand be under pavers?

One inch, screeded flat, over a compacted gravel base. Deeper than 1.5 inches and the bedding layer compacts unevenly, which is what makes pavers rock. The structural work is done by the base stone, not the sand.

How many bags of sand are in a cubic yard?

Fifty-four 50 lb bags, at 0.5 cubic feet each. That is why bagged sand is only sensible for sandboxes and small patching jobs — a cubic yard in bags costs four to five times the bulk price.

Is masonry sand the same as play sand?

No. Masonry sand is coarse and angular so bedding locks up; play sand is washed, rounded and screened fine. Using masonry sand in a sandbox is unpleasant, and using play sand under pavers means the bed never consolidates.

REL

Related calculators