Crushed stone calculator
Crushed stone is sold by the ton far more often than gravel, because a yard of it is heavy enough to max out a truck. Put your dimensions in below and you get both units.
Base layers compact in 4 in lifts; surface stone 3–4 in.
Affiliate link. The price above is calculated from the unit price you entered — it is not a quote.
A 20 ft × 10 ft area at 4 inches deep needs about 2.72 cubic yards of crushed stone, or 3.7 tons — 73 cubic feet once a 10% waste allowance is included. Crushed stone sits near 100 lb per cubic foot, so a cubic yard weighs about 1.35 tons and the tonnage is what most yards will quote you.
Why crushed stone is quoted by weight
A cubic yard of crushed stone weighs around 2,700 lb. A typical tandem-axle dump truck carries about 15 tons, which is only 11 cubic yards — well short of what the bed could hold. So the yard sells by the ton, the truck is limited by weight, and your invoice arrives in tons.
The calculator gives you both numbers so the quote and your measurement can be compared directly.
Graded sizes and what they are for
| Size | Common name | Use |
|---|---|---|
| 3/8 in | Chips | Paths, pipe bedding, decorative topcoat |
| 3/4 in | #57 | Driveway base, drainage, concrete aggregate |
| 1.5 in | #3 | Heavy base, road sub-base, fill |
| Stone dust | Crusher run | Paver setting bed, compactable base |
Graded stone has been screened to a narrow size band. Crusher run has not — it includes the fines, which is why it compacts into a hard, near-concrete surface and why it drains poorly.
Base layers versus surface layers
A driveway is usually two materials, not one. The base is 4–6 inches of #57 or crusher run, compacted. The surface is 2–4 inches of a smaller stone, or the same stone at a finer grade.
Run them through the calculator as two separate calculations. Adding them together in one pass gives you the right total tonnage but the wrong depth per layer, and depth is what decides whether the base actually carries load.
Where the number goes wrong
Compaction loss. Crusher run compacts by up to 20%. Graded stone compacts by 10–15%. The material ordered does not shrink, but the layer does — so build to a thicker loose depth than the finished depth you want.
Fines washing out. Stone without fines drains well and loses its surface structure over time. If the area takes runoff, line the trench with filter fabric before the stone goes in, or the voids will fill with soil within a couple of seasons.
Mixing sizes. A load that arrives with too many fines is not #57 no matter what the ticket says. Check a shovel of it against the size range before it goes down — rescreening after the truck leaves is not an option.
Crushed stone questions
What is the difference between #57 stone and 3/4 inch crushed stone?
They are close to the same thing. #57 is a graded size designation — stone that passes a 1 inch screen and is retained on a No. 4 sieve — and 3/4 inch is the nominal top size most yards sell under that label. Both compact well and drain freely, which is why they are the default for driveway base and drainage.
How many tons of crushed stone do I need per square foot?
At 4 inches deep, one square foot takes about 0.012 cubic yards, or roughly 33 lb of stone. A 100 square foot patio base therefore needs about 1.2 cubic yards, or 1.65 tons, before waste. Multiply your square footage by 0.0165 to get tons at that depth.
Should I use crushed stone or gravel for a driveway?
Crushed stone for the base, either for the surface. Angular faces lock together under compaction, so crushed stone carries load without rutting. Rounded gravel rolls and migrates, which is fine as a decorative topper but poor as a structural layer.
How much does a yard of crushed stone weigh?
About 1.35 tons, or 2,700 lb. Dense-graded aggregate with lots of fines can run closer to 1.45 tons per cubic yard once it is compacted and damp.
How deep should a crushed stone base be?
Four inches for a garden path or patio, six inches for a residential driveway, and eight to twelve inches for anything a delivery truck will drive on. Build it in 2–4 inch lifts and compact each one — a single deep pour never compacts through.